Engine
	6.5L / 6.5L Turbo			6.2L NA
	Standard (ft-lb)	Metric (Nm)		Standard (ft-lb)	Metric (Nm)
Camshaft Thrust Plate				18	24
Cam Sprocket-Camshaft	125	171		55-66	75-90
Connectinig Rod Cap	45-52	61-71		45-52	61-71
Cylinder Head	See Service Bulletin 98-02-03
Initial	20	27		20	27
Final	55	75		50	68
Angle	90-100 deg (1/4 + turn)			90 deg (1/4 + turn in seq.)
Exhaust Manifold	26	35		18-25	24-34
Flexplate to Crank	65	88		65	88
Glow Plug	13	18		13	11-26
Injector Lines to Pump & Nozzle	24	33		20	27
Injector Nozzle	44-60	60-82		13-20	18-27
Injector Pump Gear-Pump Shaft	13-20	18-27		44-60	60-82
Intake Manifold	31	42		30	40
Lifter Retainer	15-20	20-27		15-20	20-27
Main Bearing Cap	(94-96)
Initial/short	40	54		40	54
Initial Long	40	54		40	54
Final/Short	100	136		100	136
Final/Long	110	149		110	149
Main Bearing Cap 97-99 See Hummer Service Bulletin 98-02-02
Oil Pan
6mm	89	10		48-120	5-14
8mm	17	23		156-240	18-27
Oil Pan Drain Plug	20	27
Oil Pump Drive	25-37	34-50		25-37	34-50
Oil Pump Mounting
Stud	66	90		59-74	80-101
Nut	35	48		35	48
Rocker Shaft	41	56		41	56
Starter	40	54		40	54
Timing Gear Cover	33	45		33	45
Thermostat Housing				31	42
Torsional Damper	200	270		140-162	190-220
Turbocharger Mount Bolts	43	58
Turbo Exhaust Clamps	90	10
Rocker Cover Bolt	13-25	18-34		13-25	18-34
Water Cross-Over to Cylinder Head	25-37	34-50		25-37	34-50
Water Pump to Cover
8mm	13-20	18-27		13-20	18-27
10mm	25-37	34-50		25-37	34-50
Water Pump to Plate	13-20	18-27		13-20	18-27
				Key
				Pipe Thread Sealant
				Thread Locker Blue
				Thread Locker Red
				Anti-Seize (GM P/N 1052771)
Alignment Specifications (All Models Unloaded)
Front
	Camber	1.05	±	0.25
	Caster	1.80	±	1.00
	Toe	0.00	±	0.03
Rear
	Camber	1.05	±	0.25
	Caster
	Toe	0.00	±	0.03